Daytona Twin Tec Oxygen Sensor Eliminator Kits – Exhaust

These O2 sensor eliminator kits are used when you want your bike to run without O2 sensors, for example when you want to change air/fuel ratio at idle and part throttle for racing applications using Diag4Bike, Daytona Twin Tec Twin Tuners in conjunction with a Daytona Twin Scan Tool, Dynojet Power Commander, Screamin' Eagle Pro Super Tuner and similar. The eliminators plug into the stock wiring harness and simulate a cold sensor condition, causing the ECM to remain in "open-loop" operation. Eliminators for 4-wire heated sensors can also be used to eliminate the secondary O2 sensors on Euro-5 motorcycles but then their only function is to keep moisture and dirt out of the wiring side connectors to keep them intact for later use. Related CEL (Check Engine Light) and DTC (Diagnostic Trouble Code) warnings can be disabled with Diag4Bike software and a Diag4Bike Tuning License.

Daytona Twin-Tec, Fits 2012 to present Softail (except 2018-2024 Sport Glide and Fat Bob), 2010 to present Touring & Trike, 2012-2017 Dyna and 2007-2013 Sportster with 4-wire heated M14 threaded O2 sensors, including Euro-5 rear sensors. Contains one black and one grey connector

Twin Tec 02 bypass kit 4-wire BT12-UP

• Category: Sensors